14
en
Working instructions.
Before mounting or replacing cutting tool or accessories, pull the power plug.
This preventive safety measure rules out the danger of injuries through acci-
dental starting of the power tool.
For each job, use only the FEIN application tool released and intended for the respec-
tive application.
Switching on and off.
Check the power supply
cable and the plug for dam-
age.
Always hold the power tool
firmly.
Otherwise, you could
lose control over the power tool.
Guide the power tool toward the work
piece only when switched on.
While cutting, hold the power tool as
upright as possible to the work-piece sur-
face.
Guide the power tool uniformly and with
light feed in the cutting direction. Excessive
feed considerably reduces the tool life of the
application tools.
Do not cut steel sheets where welded. Do
not cut layered sheets exceeding the max.
work-piece thickness.
To increase the tool life of punch and die, it
is recommended to apply a lubricating agent
alongside the intended cutting line:
–
For cuts in steel sheet: Use cutting paste
or cutting oil.
–
For cuts in aluminum: Use petroleum.
For inside cuts, a pilot hole is required; see
Technical data for diameters.
Do not switch the power tool off until after
having removed it from the cutting path.
Switching on and off (figure 5).
Switching on:
Push the switch toward the front
(I)
.
Switching off:
Press the switch downward
(
)
.
WARNING
WARNING
CAUTION
Fig. 5
On/Off switch
