ASye 636 Kinetik / ASke 636 Kinetik
9
EN
Operating instructions for drill.
Overview.
1 Quick-clamping drill chuck
Insert the tool and clamp.
2 Switch
Switching ON/OFF (a),
Locking for continuous mode (b).
3 Changing the drill chuck
Changing with 2 wedge drifts.
4 Supplied accessories
ASye: Quick-clamping drill chuck for
drill bits with a diameter of 0 – 8 mm.
ASke: Quick-clamping drill chuck for
drill bits with a diameter of
0.5 – 10 mm.
For your safety.
Before using this power tool, read
and comply with:
these operating instructions,
the enclosed safety instructions (docu-
ment number 3 41 30 054 06 1),
the relevant national industrial safety reg-
ulations.
These operating instructions and the
enclosed safety information should be
kept carefully for later use and enclosed
with the machine, should it be passed on
or sold.
Intended use.
This power tool is intended for:
commercial use in industry and trade,
for drilling metal, wood, plastics and
ceramics.
Do not exceed the maximum drill size
(see “Specifications”).
Safety instructions.
Risk of injury
When drilling by hand, hold the power
tool firmly. If the power tool should sud-
denly slow down (e. g. due to a jammed
drill bit) it could twist the hand or fall
down.
Only work with undamaged, sharp drill
bits.
The drill bit and the chips can become hot
during drilling.
Beware of any concealed electric cables,
gas or water conduits; check the working
area with a metal detector, for example.
Do not rivet or screw any name-plates or
signs onto the power tool. The protective
insulation can thereby be rendered inef-
fective. Adhesive labels are recom-
mended.
Only use an undamaged plug and cable.
Damage to property/material
Mains voltage must correspond with the
voltage specifications on the power tool.
Personal protective equipment.
When using this power tool wear the fol-
lowing protective items:
Protective glasses, sturdy shoes, ear pro-
tection, hair net (for long hair).
!
!
ASye/ASke 636 - Buch Seite 9 Mittwoch, 27. September 2000 9:04 09
