20
en
Adjusting the gear setting
(ASCM18 QSW (**)) (figure 14).
Always slide the gear selector to the stop.
Otherwise, the machine can become dam-
aged.
You can adjust 4 gear settings.
Set the lowest gear setting to work at low
speed with high torque. This gear setting is
suitable for screwing in large screw diameters.
Set the highest gear setting to work at high
speed with low torque. This gear setting is
suitable for drilling with small drill bit diame-
ters.
The material-dependent gear setting can be
determined by practical testing.
Adjust the rotation direction only when
the machine is at a complete stop.
Switching on and off (figure 15).
Always hold the power tool
firmly.
Otherwise, you could
lose control over the power tool.
In case of overload, the machine switches off.
Thermal overload of the power tool is indi-
cated through flashing of the LED in the han-
dle.
Switching on:
Press the On/Off switch. The speed increases
the more you press the On/Off switch.
Switching off:
To switch off the power tool, release the
On/Off switch.
Gear selector
Fig. 14
CAUTION
1.
2.
Fig. 15
On/Off switch
OBJ_BUCH-0000000311-001.book Page 20 Friday, May 4, 2018 9:20 AM
