Fein ABLK18-1.3TE, Original Instructions Manual

Page: 15 / 140

15
en
For your safety.
Read all safety warnings and all
instructions.
Failure to follow the
warnings and instructions may result in electric shock,
fire and/or serious injury.
Save all warnings and instructions for future reference.
Do not use this power tool before you have thor-
oughly read and completely understood this
Instruction Manual and the enclosed “General
Safety Instructions” (document number
3 41 30 054 06 1). The documents mentioned should be
kept for later use and enclosed with the power tool,
should it be passed on or sold.
Please also observe the relevant national industrial safety
regulations.
Intended use of the power tool:
Hand-guided nibbler for cutting sheet metal, cut-outs and
tight curves in weather-protected environments without
water supply using the application tools and accessories
recommended by FEIN.
Special safety instructions.
Wear personal protective equipment. Depending on appli-
cation, use face shield, safety goggles or safety glasses.
Where appropriate, wear dust mask, hearing protectors,
gloves and workshop apron capable of stopping small
abrasive or workpiece fragments.
The eye protection
must be capable of stopping flying debris generated by
various operations. The dust mask or respirator must be
capable of filtrating particles generated by your opera-
tion. Prolonged exposure to high intensity noise may
cause hearing loss.
Secure the work piece firmly. A work piece that is
gripped tightly in a clamping device or vice, is more
secure than if held by hand.
Do not rivet or screw any name-plates or signs onto the
power tool.
If the insulation is damaged, protection
against an electric shock will be ineffective. Adhesive
labels are recommended.
Do not use accessories which are not specifically
designed and recommended by the power tool manufac-
turer.
Safe operation is not ensured merely because an
accessory fits your power tool.
Character Unit of measure-
ment, international Unit of measure-
ment, national Explanation
U
V V Rated voltage
n
0
/min, min
-1
, rpm,
r/min
rpm Stroke rate at no-load
n
S
m/min m/min Cutting speed
M...
mm mm Size of metric thread
Ø mm mm Diameter of a round part
mm mm Max. work-piece thickness for steel with up
to 400 N/mm
2
mm mm Max. work-piece thickness for steel with up
to 600 N/mm
2
mm mm Max. work-piece thickness for steel with up
to 800 N/mm
2
mm mm Max. work-piece thickness for aluminium with
up 250 N/mm
2
mm mm Diameter of pilot-drill for inside cut-outs
mm mm Min. inside curve radius
kg kg Weight according to EPTA-Procedure 01
L
pA
dB dB Sound pressure level
L
wA
dB dB Sound power level
L
pCpeak
dB dB Peak sound pressure level
K... Uncertainty
m/s
2
m/s
2
Vibrational emission value according to EN 60745
(vector sum of three directions)
h
m/s
2
m/s
2
Vibrational emission value (nibbler)
m, s, kg, A, mm, V,
W, Hz, N, °C, dB,
min, m/s
2
m, s, kg, A, mm, V,
W, Hz, N, °C, dB,
min, m/s
2
Basic and derived units of measurement from the
international system of units
SI .
Fe 400
Fe 600
Fe 800
Al 250
WARNING
OBJ_BUCH-0000000259-001.book Page 15 Thursday, May 12, 2016 3:40 PM