IDENTIFICATION
ID CPR60
Page 12 of 22
5 Standby / Low Power Card Detection
The ID CPR60 offers a standby mode to reduce the power consumption to a minimum. The standby mode
can be controlled by the host via input nLOW_PWR (see:
).
The standby mode is activated if input nLOW_PWR is set to low. In this mode the reader wakes up if:
-
a contactless card is detected in front of the RFID antenna or
-
if the Input nKCC_DET is set to 0
The reader remains active for a configurable time. Even if nLOW_PWR is set to high during this time the
reader remains active as long as nLOW_PWR is set to high.
The host can switch the reader at any time back into the standby mode with command [0x64] System Reset.