OBID
i-scan
®
HF
Installation
ID ISC.M02
FEIG ELECTRONIC GmbH
Page 15 of 27
M20301-4e-ID-B.doc
3.4 Operating elements
3.4.1 Operating/Programming Mode: Jumper J1
Jumper J1 is used to configure the operating and programming mode of the ID ISC.M02.
In standard operation the jumper is set to Position 1-2 (see Fig. 4.3.1-1). The reader is then in
normal operating mode.
If the jumper is set to Position 2-3, the integrated hardware bootloader starts after a reset. Since
the reader’s firmware however also has a software bootloader, the hardware bootloader option
should be used only for installing the software bootloader.
For additional information about programming the reader, see the corresponding Application Note
“N21101-xe-ID-B” „Firmware Update“.
Jumper position
Mode
1 - 2
Standard setting
:
The reader is in normal operating mode.
2 - 3
Activation of the hardware bootloader:
After a reset the reader’s CPU starts its hardware
bootloader, which can then be used for new pro-
gramming.
Table 7
: Jumper J1
Fig. 6
: Jumper J1
J1
1
2
3
J2
J3
X2
X3
X4
Standard-
setting
X1
J1
V2
V1
C65
C73
