IDENTIFICATION
ID PAD74-U
INSTALLATION
Page 10 of 15
•
Remove rubber
feet
•
Use drilling pattern,
(see Fig. 3)
•
The predrilled
holes (2.0 mm) are
located under the
rubber feet.
Figure 6: Remove rubber feet
Figure 7: Predrilled holes (2.0 mm)
•
Drill out factory
holes from 2.0 mm
to 4.0 mm
Figure 8: Drill out factory holes to 4.0 mm
•
The under-table
mounting is carried
out via the rear of
the housing using
pan head screws
(max. M3 x 3.5
mm).
•
The four pan head
screws must
penetrate the top of
the antenna.
Figure 9: Pan head screws (max. M3 x 3.5 mm)
