OBID
i-scan
®
UHF
Manual
ID ISC.MU02.02
FEIG ELECTRONIC GmbH
Page 31 of 96
H90701-3e-ID-B
7.3. CFG2: Inputs / Outputs general
Via the following parameters the operation mode of the LED can be configured at any time. One
byte each is reserved for the active and mute position, by means of which the individual operation
modes according to the schedule below may be adjusted. In addition to this, for the active- and
mute position different flashing frequencies of the LED may be defined. So, the LED may be used
as an operation indicator.
The Reader’s LED can be configured through software.
Byte
0
1
2
3
4
5
6
Contents
0x00
0x00
0x00
IDLE-STATE
IDLE-FLASH
0x00
0x00
Default
0xA9
0x00
Byte
7
8
9
10
11
12
13
Contents
ACTIV-
STATE
ACTIV-
FLASH
ACTIV-
GRN-TIME
ACTIV-
BLUE-TIME
ACTIV-
RED-TIME
0x00
0x00
Default
0x96
0x00
0x0A
0x0A
0x0A
1 sec.
1 sec.
1 sec.
IDLE-STATE / ACTIVE-STATE (DigitalIO.Signaler……State)
One byte each for idle- and tag-detect state is used to set the operation mode of the sig-
nal transmitter.
Bit:
7
6
5
4
3
2
1
0
Function:
Startup /
LED
0
RED
BLUE
GRN
Bit combination
LED State
b01
b10
b11
on
off
flashing
GRN (DigitalIO.Signaler.LED.Green….State)
BLUE (DigitalIO.Signaler.LED.Blue….State)
RED (DigitalIO.Signaler.LED.Blue….State)
Startup LED
(only idle state)
(DigitalIO.Signaler.Enable_StartupSignal)
When this option is selected, the Reader will switch the LEDs on for two seconds
to indicate that the Reader is ready after the Reader is powered. If the Reader is
reset by software, only both LEDs switch on for 2 seconds.