IDENTIFICATION
ID MAX.U500i
10 Radio Approvals
Page 32 of 36
10.2 USA (FCC) and Canada (IC)
10.2.1 USA (FCC) and Canada (IC) Warning Notices
Product name:
ID MAX.U500i-FCC
FCC ID:
IC:
PJMLRU500i
6633A-LRU500i
Notice for USA and
Canada
This device complies with Part 15 of the FCC Rules and with ISED licence-exempt RSS
standard(s).
Operation is subject to the following two conditions.
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation.
Unauthorized modifications may void the authority granted under Federal communications
Commission Rules permitting the operation of this device.
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is likely
to cause harmful interference in which case the user will be required to correct the interference
at his own expense.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux
CNR d'Innovation, Sciences et Développement économique Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage ;
(2) l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
NOTE:
Changes or modifications made to this equipment not expressly approved by
FEIG ELECTRONIC GmbH may void the FCC authorization to operate this equipment.
10.2.2 Installation with FCC/IC Approval
To comply with FCC Part 15 Rules in the United States / IC Radio Standards in Canada, the system must be
professionally installed to ensure compliance with the FCC Part 15 certification / IC certification. It is the
responsibility of the operator and professional installer to ensure that only certified systems are deployed in
the United States / Canada.
The system is intended for industrial and commercial use and requires professional installation. The device
and the software required for commissioning and operation are only available from FEIG ELECTRONIC or its
distributors.
Installation, commissioning, configuration and operation require qualified knowledge of high-frequency and
RFID technology due to its complexity. The connections used are from the industrial sector.
