ENGLISH (Original instructions)
Before carrying the tool, always apply the chain brake and remove the battery cartridges from the tool. Then attach the
guide bar cover. Also cover the battery cartridge with the battery cover.
Sharpen the saw chain when:
•
Mealy sawdust is produced when damp wood is cut;
•
The chain penetrates the wood with difficulty, even when heavy pressure is applied;
•
The cutting edge is obviously damaged;
•
The saw pulls to the left or right in the wood. (caused by uneven sharpening of the saw chain or damage to one side
only)
Sharpen the saw chain frequently but a little each time. Two or three strokes with a file are usually sufficient for routine
resharpening. When the saw chain has been resharpened several times, have it sharpened in our authorized service
center.
Sharpening criteria:
—
All cutter length must be equal. Different cutter lengths prevent the saw chain from running smoothly and may
Do not cut right through the fibers under any circumstances. The tree will otherwise fall unchecked.
NOTICE:
Only plastic or aluminum wedges may be used to keep the back cut open. The use of iron wedges is
prohibited.
Carrying tool
1.Guide bar cover 2.Battery cover
MAINTENANCE
Always be sure that the tool is switched off and the battery cartridge is removed before attempting to
perform inspection or maintenance.
Always wear gloves when performing any inspection or maintenance.
NOTICE:
Never use gasoline, benzine, thinner, alcohol or the like. Discoloration, deformation or cracks may result.
Sharpening the saw chain
An excessive distance between the cutting edge and depth gauge increases the risk of kickback.
1.Cutter length 2.Distance between cutting edge and depth gauge 3.Minimum cutter length(3mm)
23
