ENGLISH (Original instructions)
1. Press the lock-off lever, then pull the switch trigger. The saw chain starts immediately.
2. Push the front hand guard forwards with the back of your hand. Make sure that the chain saw comes to an immediate
standstill.
Run the chain saw then release the switch trigger completely. The saw chain must come to a standstill within one
second.
You can adjust the oil pump feed rate with the adjusting screw. The amount of oil can be adjusted using the universal
wrench.
Checking the chain brake
Hold the chain saw with both hands when switching it on. Hold the rear handle with your right hand, the front
handle with your left. The bar and the chain must not be in contact with any object.
Should the saw chain not stop immediately when this test is performed, the saw may not be used under any
circumstances. Consult our authorized service center.
1.Front hand guard
2.Unlocked position
3.Locked position
Checking the run-down brake
If the saw chain does not stop within one second in this test, stop using the chain saw and consult our
authorized service center.
Adjusting the chain lubrication
14
