Feider Machines Fm20V115, Instruction Manual

Page: 20 / 24

１１
slide the switch to the left, Fig 14.
n. CIRCLE CUTTING
When starting a cut from the center of the work piece, drill a 12mm diameter hole to
ensure that there is enough clearance for the blade.
When cutting materials with a decorative or polished finish cover either the base of the
jigsaw or the surface of the material being cut with masking or other suitable tape to
prevent scratching.
3. MAINTENANCE
a. Maintenance
After each use, remove the accumulator from its compartment and check for damage.
Correct maintenance is essential to maintain the original efficiency and safety of the
machine over time.
Keep all nuts, bolts and screws tight to be sure the equipment is in a safe working
condition.
Never use the machine with worn or damaged parts. Damaged parts are to be replaced
and never repaired.
Only use original spare parts. Parts that are not of the same quality van be seriously
damage the equipment and compromise safety.
During maintenance, remove the battery from the tool.
To avoid overheating and damage to the motor, always keep the cooling air vents clean
and free of sawdust and debris.
Clean the housing only with a damp cloth. Do not use solvents! Then wipe thoroughly.
Check the condition of the tool. If the tool is damaged or has malfunction, do not use it and
bring it to a qualified service for inspection or reparation.
To maintain the optimum battery power, we recommend that the battery be discharged and
recharged every two months.
b. Storage
Remove the battery from the tool.
Put the blade protection on the blade of the tool during transport and storage.
Store the tool in a dry place and protected from freezing, the ambient temperature should