• Do not cut fragments which are too small and which do not enable fastening them securely
on the guide bar and keeping hands at a safe distance from the cutting blade.
• Make sure that there are no foreign objects on the machine bench.
• In case of binding of any objects in the machine disconnect it from the power source to
remove the jammed objects.
• Do not remove the jammed object while the machine is still working.
• Do not allow the machine to work without water. The absence of water in the tank results in
cutting blade overheating which leads to the breakdown thereof and incorrect tile cutting.
• Do not try to modify the machine or its auxiliaries.
• Do not overload the machine – it must perform its job; absence of overload reduces the wear
of the machine and of the cutting blade, it increases its work efficiency and service life.
• When working on the machine use ear and eye protection.
• Work on the tile cutter in waterproof protective clothing.
• Decorative surfaces should be cut with the tile cutter using the dust shield and a plastic
waterproof shield.
Rules for the installation of parts of the equipment
CAUTION!
Do not connect the plug to the power source before the machine is completely
assembled and adjusted, before reading and understanding the safety and operating
instructions.
Installation of supports. (Fig. 2)
• Turn the tank (14) upside down and place it
on a level and stable surface.
• Insert the four supports in the openings in
the water tank.
• Tighten the screws by hand.
• Turn the tank with supports around and
place it on a level and stable surface.
Fig. 2