The concentration of processed gases that can displace breathing air shall be kept within acceptable levels. The user
shall see the norm EN 12021 for acceptable levels of contaminants in breathing air.
Separators, traps and draining facilities are required to process liquids produced by the compressor before putting the
compressor unit into use as these are not supplied;
9.
Unpacking
Carefully check all parts after unpacking the product from the box.
Do not throw away packaging materials until you have not reviewed carefully if they did not
remain a part of the product.
Parts of the packaging (plastic bags, paper clips, etc.) do not leave within reach of children,
could be a possible source of danger. There is a danger of swallowing or suffocating!
If you notice transport damage or while unpacking, notify your supplier immediately. Do not
operate the product!
We recommend save the package for future use. The packaging materials must still be recycled
or disposed of in compliance with the relevant legislation. Sort different parts of the packaging
according to material and hand it to the appropriate collection sites. For further information
contact your local administration.
Fasteners can become loose during transport in the packaging.
PACKAGE CONTENTS
1x compressor body, 2x wheel with assembly kit (for 24L, 50L), 2x feet with assembly kit, 1x air filter, 1x
manual for use
•
Standard accessories are subject to change without notice.
This product requires assembly. The product must be assembled correctly before use
After unpacking the box check the status of the compressor for signs of damage. In particular, carefully
check the air nozzle.
Place the compressor on a horizontal, flat and firm surface so that the compressor body is directed
upward.
Install transport wheels (if not already installed) to the holders of the wheels on the bottom of the air
nozzle using screws enclosed
(fig. 2).
Install support foot (if not already installed) to the holder on the bottom of the air nozzle using screw
enclosed
(fig. 3).
Put the air filter on the thread and tighten it clockwise with your hand
(fig. 4).
Check the tightening of the air tank drain valve
(fig. 7).
Locate the compressor in a clean, dry and well-ventilated area. The compressor should be located 12 to 18
inches from a wall or any other obstruction that would interfere with the air flow through the fan. Place
the compressor on a firm level surface. The compressor is designed with heat dissipation fins that allow for
proper cooling. Keep the fins and other parts that collect dust or dirt clean. A clean compressor runs cooler
and provides longer service. Do not place rags, containers, or other material on top of the compressor.
Set the maximum pressure and connect compressor to the power supply. After reaching the maximum
pressure, properly working compressor off and then check by listening for leaks of compressed air. If you
Summary of Contents for FC24LS
Page 5: ......
