Feel-Maestro MR404, Owner'S Manual

Page: 4 / 27

6 7
ATTENTION!
- Do not open the cover when the device is in operation.
Disconnect the coffee machine from the mains and leave it to
cool for at least 5 min. when it is necessary to pour some water or
change the coffee powder or tea.
- Do not move around a switched on device when in operation.
- Do not fill the machine with water to the level above the MAX.
- Place the machine only on a dry, even, stable, slip-proof surface.
- Be careful with cups full of hot drinks.
In case of failure to observe the above mentioned rules there
arises the danger of burning!
- Do not place the appliance on heating devices.
- Do not switch the appliance on without water.
- Switch on the machine only when the teapot with the filter is
placed in position.
- Before making each new portion of the drink, unplug the Coffee
Maker and allow it to cool for at least 5 minutes.
- THIS APPLIANCE IS FOR HOUSEHOLD USE ONLY. DO NOT USE
THE APPLIANCE FOR ANYTHING OTHER THAN INTENDED USE.
Purchase industrial devices for commercial use.
Actions in extreme situations:
- If a device tumbled into water, immediately, unplug the device, not
touching to the device or water.
- In case of appearance from appliance of smoke, sparkling, strong
smell of a burn isolation, immediately stop use the device, unplug
the device, appeal to the nearest service center.
Operation
Before the first use:
- Remove packing and advertising materials and stickers.
EN
- Inspect the appliance and make sure that there are no
damages appliance, power line cord and plug.
- Unwind the power line cord completely.
CAUTION! Is required on surfaces where heat may cause a
problem – an insulated heat pad is recommended.
It is recommended to perform 1-2 working cycles with water but
without coffee.
For this purpose:
- place the coffee machine on a stable even surface;
- install the filter in the teapot case or check that it is installed
correctly;
- open the cover and fill the machine with clean cold water
controlling the level by marks MIN, MAX inside the container.
ATTENTION. If the water level in the container exceeds the mark
MAX, water shall begin to drain from the holes situated on the back
side of the case.
- close the cover;
- place the cups on the tray;
- connect the plug to the socket and switch on the machine by
positioning the switch to position «1»-ON. The indicator will light up
and the machine will start operating.
- After there remains no water in the teapot, switch off the machine
with the switch by placing it in position «0»- OFF. The indicator will
go out and the device will be disconnected. The heating of water
can be stopped at any moment by pressing the switch.
Let it cool for 5 minutes, pour out the water from the container.
Repeat the above mentioned procedure for 1-2 times.