mr
.
steam
®
Electric Towel Warmers
Installation and Operating Instructions
________________________________________________________________
6
MODELS W500
TO PREVENT SHOCK HAZARD, BE CERTAIN
THAT ELECTRICITY IS TURNED OFF AT THE MAIN PANEL BEFORE
ANY WIRING IS DONE.
Box Contents
• Towel Warmer
• (6) Screws
• (1) Upper Threaded Flange
• (1) Lower Wiring Flange
• (1) Small Allen Key
• (1) Large Allen Key
• Instruction & Operation Manual
• Warranty
1. Remove the Towel Warmer and parts from the packing materials.
2. Rotate the upper bracket as shown.
IMPORTANT:
DO NOT LOOSEN SCREWS TO SWIVEL
BRACKETS. LOOSENING SCREWS WILL CAUSE INTERNAL
LIQUID TO ESCAPE AND CAUSE PRODUCT DAMAGE.
3. Spin on upper threaded flange as shown.
4. Using the smaller allen key provided, loosen the wiring box
set screw. DO NOT remove the wiring box.
5. Rotate the wiring box as shown. Tighten the set screw firmly to
prevent the wiring box from rotating.
6. Place the Towel Warmer in the desired location and mark the
location of the upper threaded flange and wiring box. Use a level
to insure proper alignment.
NOTE:
the Towel Warmer swing range.
7. Mount the lower wiring box per instructions on page 7.
If a single gang electric box has been roughed-in,
then see page 3 for installation instructions.
Install Towel Warmers in upright position only.
Locate with indicator light on bottom as shown. Failure to install
properly may result in overheating and a hazardous condition.
Level
Upper Support Bracket
Upper Threaded Flange
Wiring
Box
This
End
Up
!
WARNING
!
WARNING
!
WARNING
