feedback AntennaLab 57-200-USB, Operator'S Manual, Page: 16 / 31

Chapter 2
BoufoobMbc!
OPERATOR’S MANUAL Installing
BoufoobMbc
57-200-USB 2-3
2.3.1 Customers Upgrading from 57-200 to 57-200-USB
If you are upgrading from the earlier 57-200 to 57-200-USB, using the 57-202
BoufoobMbc Upgrade Pack, proceed as follows:
1. The cable from the MICA8 card to the generator is not required when using 57-200-
USB and should be removed from the system. (Though this cable should be
retained if you think you may use the 57-200 software again.)
2. Proceed as directed in the following sections.
2.3.2 Installing Feedback USB Devices
1. Before connecting hardware, install the driver software.
2. Ensure that the USB interface unit is not connected to any other device.
3. Connect the interface unit directly to a USB port on your computer using a
USB cable.
The operating system should detect that a USB device has been connected to the
computer and the installation should proceed automatically as shown in Figure 2-1.
Figure 2-1
During the installation, you may be prompted one or more times for the path where a ‘sys’
file is located, as in the following example (see Figure 2-2).
Figure 2-2