11
Installing the Viper EXT Series LED Light Heads
7. Route the wires from the module through the hole in the mounting surface
Figure 2
5SEGROMMETSWIRETIESLOOMSANDCABLEMOUNTSNOTSUP
-
PLIED ASNEEDEDTOSECUREANDPROTECTTHEWIRING
Figure 2: Mounting the
V
IPER
EXT
from the rear
3ECURE THE MODULE FROM THE BACK WITHOUT THE GASKET AND BEZEL TO THE
mounting surface with the sheet-metal screws provided.
Wiring the
V
IPER
EXT
in the Vehicle
WIRING PRECAUTION
Never attach both the orange wire AND the yellow wire from the CON-
TROLLER light head to the same FOLLOWER light head. Connecting
both signal wires to the same FOLLOWER will cause the light heads to
malfunction.
REVERSE POLARITY / MISWIRING
Reverse polarity or incorrect voltage may damage the light. To avoid dam-
age to the light, ensure that the battery voltage is the same as the voltage
rating of the light and that the correct polarity is observed. If you are con-
necting to a cigarette lighter plug, connect the positive wire to the center
terminal and connect the negative wire to the outer terminal.
Make the connections shown in
Figure 3
ONPAGE&ORSINGLELIGHTHEADAP
-
PLICATIONSANDAPPLICATIONSUSINGALTERNATIVEmASHINGCONTROLSUCHASA&EDERAL
Signal
I
NTELLI
-F
LASH
ÍCUTANDSEALTHEORANGEANDYELLOW
V
IPER
EXT
wires.
V
IPER
EXT
LED
LIGHT HEAD
MOUNTING
SURFACE
#8 SCREWS