10
Installing the Viper EXT Series LED Light Heads
AIRBAG DEPLOYMENT
Do not install equipment or route wiring in the deployment path of an
airbag.
Failure to observe this warning will reduce the effectiveness of the air bag, or
potentially dislodge the equipment, causing serious injury to you or others.
DRIVER VISION
Do not install the light in a location that will obstruct or impair the driver’s
vision. Always locate the light out of direct view of the driver and test the
system to make sure excessive stray light from this light does not impair the
driver’s vision. Make sure you minimize both direct light and reflected light
from the driver’s vision.
Failure to follow this warning could result in injury or death.
DRILLING PRECAUTIONS
Before drilling holes, check the area into which you plan to drill to ensure
you do not damage vehicle components while drilling. All drilled holes
should be deburred and all sharp edges should be smoothed. All wires going
through drilled holes should be protected by a grommet or convolute/split-
loom tubing.
The
V
IPER
EXT
IS DESIGNED TO BE MOUNTED HORIZONTALLY PREFERABLY WITH THE
,%$SUP4OMOUNTTHE
V
IPER
EXT
,%$MODULETOTHEVEHICLEFROMTHEBACK
WITHOUTABEZELANDGASKET
$ETERMINETHEMOUNTINGLOCATIONFORTHE
V
IPER
EXT
module.
5SINGTHEGASKETASATEMPLATESCRIBETHELOCATIONSOFTHEINNERHOLESONTHE
mounting surface.
3CRIBEAWIREROUTINGHOLELOCATIONONTHEMOUNTINGSURFACEINTHECENTER
of the gasket.
5SEADRILLBITTODRILLTWOINCHHOLESATTHESCRIBEDMOUNTING
hole locations.
$RILLAINCHHOLEATTHEWIREROUTINGLOCATION
0REPARETHEHOLEFORTHEWIRESBYREMOVINGALLBURRSANDSHARPEDGESAND
inserting grommets.