![background image](http://html1.mh-extra.com/html/federal-signal-corporation/ultravoice-uv/ultravoice-uv_installation-operation-and-service-manual_3830688020.webp)
20
Operations
UltraVoice (UV)
Manual Activation
Use the manual activation switches to activate siren functions. Switches are located on
the front panel of the UV+ controller card. In addition, activating switches simultaneously
can operate specific testing and calibration features. See Table 8.
Figure 4 UV+ Controller Card Switches
Table 8 Manual Activation Switches on UV+ Controller Card
Function Switch
Function
CODE 1
Activates function 1
CODE 2
Activates function 2
CODE 3
Activates function 3
CODE 4
Activates function 4
CODE 5
Activates function 5
CODE 6
Activates function 6
CODE 7
Activates function 7
STOP
Reset
CODE 1 and CODE 6 Loads default speaker calibration values and transmits DTMF
characters (production testing)
CODE 2 and CODE 3 Calibrate speaker load and Xmit DTMF Quiet Test
CODE 5 and CODE 7 Transmits 1200 Hz tone for radio deviation adjustment
NOTE:
At any time during a sounding function, push the RESET button to cause the unit
to halt all output immediately.
Local Public Address
With the optional microphone (part number MNC-MC), the operator has the ability to
locally give a Public Address (PA) message. You can enter the PA mode by plugging the
MNC-MC into the microphone receptacle labeled MIC on the UV+ controller card front
panel. The PA LED is lit anytime the press-to-talk button on the microphone is depressed.
Rotating sirens start rotating to the next zone when PTT is released.
Summary of Contents for ultravoice UV
Page 42: ...42 Installation UltraVoice UV Figure 15 Omni Antenna Installation Example...
Page 43: ...43 Installation Installation Operation and Service Manual Figure 16 Antenna Grounding...
Page 71: ...71 Appendix C Drawings Figure 25 UV Controller Two way Radio Wiring Diagram...
Page 72: ...72 Figure 26 UVTD IP Broadband Wiring Diagram...