Federal Signal Corporation STREAMLINE LP3M, Installation And Service Instructions Manual

Page: 5 / 16

B. Loosen locking screw on lens and remove lens from housing by turning counter-clockwise.
C. Carefully remove the old strobe tube by grasping the connector and lifting upwards.
D. Replace lamp with Federal Signal part number K149130A. Install new strobe tube by fully
seating it into the receptacle on the printed circuit board.
E. Attach lens to housing by turning clockwise until seated.
F. Tighten locking screw on lens to secure.
III. SERVICE
The Federal factory will service your equipment or provide technical assistance with any
problems that cannot be handled locally.
Any units returned to Federal Signal for service, inspection, or repair must be accompanied by
a Return Material Authorization. This R.M.A. can be obtained from a local Distributor or
Manufacturer’s Representative.
At this time a brief explanation of the service requested, or the nature of the malfunction,
should be provided.
Address all communications and shipments to:
FEDERAL SIGNAL CORPORATION
Electrical Products Division
Service Department
2645 Federal Signal Drive
University Park, IL 60466-3195
IV. REPLACEMENT PARTS
Description Part Number
Strobe tube K149130A
Lens, Amber K8589006A
Lens, Blue K8589006A-01
Lens, Clear K8589006A-02
Lens, Green K8589006A-03
Lens, Red K8589006A-04
Gasket, LP3M K8589029A
Gasket, Lens K8589012A
Printed circuit board assy, 120VAC K2001317A
Printed circuit board assy, 240VAC K2001317A-01
Printed circuit board assy, 12-48VDC K2001316B
-3-