Q
uadra
F
lare
Halogen Scene Light Model QL97HSCENE
3
After Installation or Service
• After installation, test the light system to ensure that it is operating properly. Test all vehicle functions,
including horn operation, vehicle safety functions and vehicle light systems, to ensure proper operation.
Ensure that the installation has not affected the vehicle operation or changed any vehicle safety func-
tion or circuit.
• Scratched or dull reflectors, mirrors or lenses will reduce the effectiveness of the lighting system. Avoid
heavy pressure and use of caustic or petroleum based products when cleaning the lighting system.
Replace any optical components that may have been scratched or crazed during system installation.
• Do not attempt to activate or de-activate the light system controls while driving in a hazardous situation.
• You should frequently inspect the light system to ensure that it is operating properly and that it is se-
curely attached to the vehicle.
• After installation and testing are complete, provide a copy of these instructions to instructional staff and
all operating personnel.
• File these instructions in a safe place and refer to them when maintaining or re-installing the product.
Failure to follow all safety precautions and instructions may result in property damage, serious
injury, or death to you or others.
RETAIN AND REFER TO THIS MESSAGE
Product Overview
The Federal Signal Model QL97HSCENE halogen 9 x 7 scene light is used for a variety of Fire/EMS scene
lighting applications. This scene light uses a chromed parabolic reflector, 50-watt halogen lamp and a
fresnel lens to disperse light. It is typically used in pairs to provide suitable illumination of work areas around
the perimeter of the vehicle. The scene light operates on 12 Vdc vehicle electrical systems. Its width and
length are an industry standard to be suitable in most applications.
Unpacking the Product
After unpacking the product, inspect it for damage that may have occurred in transit. If the product has been
damaged, do not attempt to install or operate it. File a claim immediately with the carrier, describing the
extent of damage. Carefully check all envelopes, shipping labels, and tags before removing or destroying
them. Also required are red and white installer-supplied 18 AWG (minimum) wires (Figure 4 on page 9) for
wiring the scene light to the power source.
Table 1: Contents in kit PN 8012090
Qty. Description
4
Screw Grommet
4
Screw, M 4.2 x 38
1
Connector
2
Terminal
