6
Installation and Maintenance Instructions
Models QL64-BTT, QL64-TURN, QL64-ARROW, and QL64-BACKUP
2.
Models QL64-TURN, QL64-ARROW, and QL64-BACKUP
.
The QuadraFlare warning light assembly is designed to
operate on 12 VDC. Three 12-inch long lead wires are
supplied for making electrical connections to the Models
QL64-TURN, QL64-ARROW, and QL64-BACKUP warning
light assemblies.
a. Using 18-gauge (minimum) wire, connect the red (+) lead
to the positive power source terminal and the black (–)
lead to the negative power source terminal.
NOTE
:
The white wire is not used in these three models.
b. Energize the supply circuit and test the QuadraFlare
warning light assembly for proper operation.
DAMAGE TO THE LIGHT: When installing the QuadraFlare light
on a vehicle, you MUST use the manufacturer’s supplied screws
and screw grommets. Do not use an impact drill or an electric
screw gun when installing the light. Torque the mounting screws
to the manufacturer’s recommended specification of 12 in-lb +/-
10 percent.
Failure to observe these precautions will damage the light and
void any warranty claims for the light.
Safety Message to Operators
Peoples’ lives depend on your safe use of our products. Listed
below are some important safety instructions and precautions
you should follow:
• Although your warning system is operating properly, it may
not be completely effective. People may not see or heed your
warn ing signal. You must recognize this fact and continue
driving cautiously.
