Federal Signal Corporation JetSolaris JLX Series, Installation And Service Manual, Page: 22 / 34

22
Chapter 4: Installing the SignalMaster (Option)
NOTE: TWO WIRES ARE
CRIMPED IN ONE TERMINAL
NOTE: MATING FEMALE TERMINALS ARE CRIMPED
ON WIRES BEFORE CONNECTING TO SWITCHES.
CONTROL CABLE
ASSEMBLY
BLACK
RED
290A5309-01
WHITE
SWITCH BRACKET
REAR VIEW
JUMPER WIRE FROM
INSTALLATION KIT
GREEN
RED
GOLD
TERMINAL
OFF-ON
SWITCH
CHASSIS GROUND
HAZARD
SWITCH
3
2
1
3 2 1
CAUTION
IMPROPER WIRING OF THE ILLUMINATED SWITCH FEATURE
WILL RESULT IN P.C.B. DAMAGE. ENSURE THAT THE CHASSIS GROUND
LEAD (22 AWG BROWN) IS CONNECTED TO THE GOLD (PIN #3) TERMINAL.
BROWN
Figure 4.2: Connections for SignalMaster control head
Table 4.1: SignalMaster control cable wires
Color Description
Red +12 Vdc
Brown Chassis
Green Center Out directional pattern
White Left arrow directional pattern
Black Right arrow directional pattern
White/Green Not used
Operating the Control Head
The control head has a power switch and a rocker switch that enables the operator to select
SignalMaster patterns.
ON/OFF Switch
When the control head's power switch is in the ON position, the LED in the switch turns on.
If the LED does not turn on, check the ground lead on the control head's mounting bracket
properly grounded to the vehicle chassis.
Rocker Switch
The patterns the switch positions display override the turn signal/brake option.
LEFT position: Displays a left-arrow flashing pattern, directing traffic to proceed around the
vehicle to the left.
CENTER position: The middle lights alternate with two outer lights on each side.
RIGHT position: Displays right-arrow flashing pattern, directing traffic to proceed around the
vehicle to the right.