16
Chapter 3: Installing the JLX JetSolaris
Programming Secondary Mode
To select a flash pattern for Secondary Mode:
1. Apply +12 Vdc to both the Primary (red) and Secondary (blue) Mode wires to turn on
the lightbar in Secondary Mode.
2. Apply GND (–) to the orange wire in the lightbar cable.
LIGHT HAZARDS
To be an effective warning device, this product produces bright light that can
be hazardous to your eyesight when viewed at a close range. Do not stare
directly into this lighting product at a close range or permanent damage to
your eyesight may occur.
3. When the pattern changes, disconnect the orange wire for a few seconds and observe
the pattern. To display the next pattern in the library, apply and remove GND (–) to the
orange wire.
4. To select a pattern, allow it to run for at least 15 seconds to save it in memory.
Programming with the PROGRAM Pushbutton
The S1 PROGRAM pushbutton is on the underside of the passenger-side end PCB directly
below the label "PROGRAM" silkscreened on the top of the board (Figure 3.2 on page 17).
Table 3.2 on page 18 lists the flash patterns in the lightbar’s library
STATIC-SENSITIVE DEVICE
This product's circuitry can be damaged by electrostatic discharge (ESD). Follow
anti-static procedures while installing this product.
NOTE: To return to the default flash pattern while programming Primary or Secondary Mode
using the pushbutton method, apply GND (–) to the orange wire for 5 seconds.
1. Use a large flat-head screwdriver to remove the two 1/4-20 screws that secure the
passenger side end dome to the aluminum extrusion (Figure 3.1) and remove the
nameplate.
Figure 3.1: Location (circles) of screws securing end dome
Summary of Contents for JetSolaris JLX Series
Page 2: ......