28
Getting Service
Informer100 Speaker Series C (Models I-IP100AC and I-IP100DC)
Federal Signal www.fedsig.com
Closing the Housing
To close the housing:
1. Verify that the cover gasket is in the groove around the perimeter of the rear cover.
2. If the front of the unit was removed, lift the front of the Informer100 to allow the hinge
pin to be installed, align the front unit with the rear cover and attach the hinge pin
with retaining clip.
3. Attach the cable between the amplifier and rear cover IP PCB. Secure the cable using
the two screw-down cable ties inside the rear cover.
4. On IP-100AC—Attach the power cable from the rear cover IP PCB to the power
supply.
On IP-100DC—Attach the power cable from the rear cover IP PCB to the amplifier.
5. Turn on the power to verify that the lights on the IP PCB are functioning. If the
environment does not allow powering, proceed to the next step.
6. Verify all connectors are seated. Also, verify wires are not strained and are not
impeding the ability to close unit.
7. Lift the front of the unit and seat the front cover against the rear enclosure.
8. Tighten the cover screws hand tight, and then torque them in alternate pattern to
60 in-lb +/- 10 in-lb.
Ordering Replacement Parts
To order replacement parts, call Customer Care. See Getting Service.
Table 8 Replacement Parts
Description
Part Number
Service Kit, 20000314-01 PCBA
Includes: IP Control PCB Only
Q-20000314-01
Service Kit, IP100, AC Model
Includes: Assembled front housing, driver, power supply, and amplifier
Q-IP100AC
Service Kit, IP100, DC Model
Includes: Assembled front housing, driver, and amplifier
Q-IP100DC
Service Part Fuse 2 per AC unit
Bussman part – GDC-3.15A
Littlefuse part p 2183.15HXP
K148186A-01
Service Part 1 per Amplifier
Littlefuse part 0297010.wxnv
Not Available
through
Federal Signal
Getting Service
If you are experiencing any difficulties, contact Federal Signal Customer Support at
800-548-7229 or 708-534-3400 extension 7511 or Technical Support at 800-524-3021
or 708-534-3400 extension 7329 or through e-mail at [email protected]. For
instruction manuals and information on related products, visit: http://www.fedsig.com/.
