Mounting the IMPAXX to a Vehicle
13
Installation and Maintenance Manual
Federal Signal
www.fedsig.com
DRILLING PRECAUTIONS: When drilling holes, check the area
you are drilling into to ensure that you do not damage vehicle
components while drilling. All drilled holes should be de-burred,
and all sharp edges should be smoothed. All wire routings going
through drilled holes should be protected by a grommet or
convolute/split loom tubing.
4.
Use a #34 drill bit to drill two 0.111-inch holes at the scribed
mounting hole locations.
5.
Drill a 1/2-inch hole at the wire-routing location.
6.
Remove all burrs and sharp edges, and insert grommets to
prepare the hole for the wires by.
7.
Route the wires from the module through the holes in the
gasket and mounting surface. See Figure 1. Use grommets,
wire ties, looms, and cable mounts (not supplied) as needed to
secure and protect the wiring.
8.
Place the mounting bezel over the module and secure it to the
mounting surface with the #6 sheet metal screws provided.
Figure 1 IMPAXX with mounting hardware
