Mounting the IMPAXX to a Vehicle
12
IMPAXX
®
LED Light Heads
Federal Signal
www.fedsig.com
For information about available flash patterns, see “Selecting a
Flash Pattern” on page 15.
Mounting the IMPAXX to a Vehicle
ROOF SUPPORT STRUCTURE:
There is a roof support piece that
spans the distance between the driver side and passenger side. DO
NOT DRILL THROUGH THIS PIECE! Adjust any hole locations until
the holes can be drilled without going through this support. Failure
to follow this warning will weaken the roof of the vehicle and may
lead to an increased chance of bodily injury or death in a rollover
accident.
LOCATING OPERATOR CONTROLS: The controls for the light
system must be located so that the VEHICLE and CONTROLS can
be operated safely under all driving conditions.
AIRBAG DEPLOYMENT: Do not install equipment or route wiring in
the deployment path of an airbag. Failure to observe this warning
will reduce the effectiveness of the airbag or potentially dislodge
the equipment, causing serious injury or death.
VISION OBSTRUCTION: Do not install the light in a location that will
obstruct or impair the driver’s vision. Locate the light out of direct
view of the driver, and test the system to make sure excessive stray
light from this light does not impair the driver’s vision. Minimize
both direct light and reflected light from the driver’s vision. Failure
to follow this warning could result in injury or death.
1.
Determine the mounting location for the IMPAXX
®
module.
2.
Using the bezel as a template, scribe the mounting-hole
locations on the mounting surface.
3.
Scribe a wire routing hole location on the mounting surface in
the center of the bezel.
