8
Introduction
One-Way to Two-Way Kit for DBFCB
Federal Signal www.fedsig.com
• Four 3/8-inch lock washers to mount antenna bracket to pole.
• Compression C-tap #2AWG
• Twenty-five clips, coax nail for nailing down the antenna cable
• Ten UV-resistant tie wraps for tie wrapping the cable to the bracket
• Tape, mocap, silicone insulated for sealing the antenna connectors.
NOTE: Seal all connections.
• Disposal bag or box to put the old parts into that will be removed.
• Radio service monitor and VSWR tester required for the radio system. Typically, radio
shop supplied.
Recommended Cables
When equipped with radio from the NX-5000 Series in your two-way RTUs, Federal Signal
recommends purchasing the following cables for computer programming:
• RIB FIF-12A USB interface cable
• CT-104A interface cable
Use the RIB FIF-12A USB cable to connect to your computer. Use the CT-104A cable to
connect from the RIB FIF-12A USB cable to the radio.
Table 1 Kit Contents
Item
No.
Qty Part Number Description
Notes
Picture
1
1
2562640
One-Way
to Two-Way
Manual for
DCFCB
Installation
Manual
2
1
1751587B-01 Cable, radio,
to FCT
Cable between
the radio and
controller board.
3
1
17500880
Cord, pwr.
Supply, radio
Radio power
cable
4
1
175902A-24
Cable, ant,
UHF/N,
12 inches
Antenna cable,
internal
5
1
169182A-01
Plate
assembly, DC
to DC convert
DC converter
plate
6
1
2005173E
PCBA, DC to
DC converter
DC converter
board
