16
Installing the Kit
One-Way to Two-Way Kit for DBFCB
Federal Signal www.fedsig.com
4. Install nut 3/8 inch on the screw stud (item 24).
Figure 8 Install nut
5. Connect the external antenna cable to the antenna lightning protection. The antenna
was installed earlier.
Figure 9 Antenna connections
6. Ensure that all the antenna connections are sealed. If this is not sealed properly,
moisture and weather may cause damage.
For installation instructions on the Yagi and Omni Antennas, go to the Federal Signal
website.
7. Ensure that the antenna cable is properly secured. A loose antenna cable flapping in
the wind may cause damage.
Refer to the Yagi and Omni Antennas Installation Manual and ensure that the antenna
and antenna cable are correctly installed.
8. Install DIN rail terminals according to the manual (items 25-30).
• Refer to the schematic section of the DCB, DCFCB and DCFCTB Models Manual.
Use the schematic for the DCFCTB.
• Pay particular attention to the yellow jumper that is inserted at TB3 (item 30).
• Ensure that the screws in the end stops are tight. If there is any confusion, refer to
schematic DCB, DCFCB and DCFCTB Models Manual.
