Model AV1-LED Lights
7
Installation and Maintenance Manual
■
Pipe Mounting
To mount the Model AV1-LED on a 1/2-inch NPT pipe:
1.
Attach the light to the pipe by turning the light clockwise.
2.
To make the electrical connections, refer to “Wiring the Model
AV1-LED” on page 9.
Surface Mounting
To mount the Model AV1-LED on a flat mounting surface:
1.
Remove and retain the three #8 screws securing the upper
housing to the lower housing. Remove the upper housing.
(Figure 1 on page 8).
2.
Using the gasket as a template or the dimensions shown in
Figure 2 on page 9, scribe three drill-position marks on the
mounting surface.
3.
Drill a 3⁄16-inch (4.8 mm) diameter hole at the two outside
drill-position marks for mounting.
4.
Drill or punch a 3⁄4-inch (19.1 mm) diameter hole at the center
drill-position mark for wire entry.
5.
Use a small punch to remove the appropriate knockouts in the
lower housing.
6.
Center the mounting holes in the rubber gasket over the
mounting holes in the mounting surface.
7.
Center the mounting holes in the lower housing over the
mounting holes in the gasket.
8.
Secure the light to the mounting surface using the two mounting
screws.
9.
Refer to “Wiring the Model AV1-LED” on page 9 to complete
the installation.
