background image

Horizontal฀Beamwidth:฀

60°฀@฀2.0฀kHz

Vertical฀Beamwidth:฀

40°฀@฀2.0฀kHz

Directivity฀Factor฀Rq฀(Q):฀

15.9฀@฀2.0฀kHz

Usable฀Low-Frequency฀Limit:฀

350฀Hz

Construction:
 

 

High-impact, acrylic styrene acrylonitrile  

 

 

(ASA) with ultraviolet light inhibiting  

 

 

 

mesa tan finish. Positive-lock super tough    

 

 

nylon swivel base.

Weight:
 

Shipping 

4.6 lbs. (2.1 kg)

 

Net 

3.8 lbs. (1.7 kg)

Housing Dimensions:
 

Width 

12.1” (30.7 cm)

 

Height 

8.9” (22.6 cm) 

 

Depth 

14.1” (35.8 cm)

C. Unpacking.

After unpacking the Model AM30T, examine it for damage that may have occurred in transit. 

If฀the฀equipment฀has฀been฀damaged,฀do฀not฀attempt฀to฀install฀or฀operate฀it.฀File฀a฀claim฀

 

immediately with the carrier stating the extent of the damage. Carefully check all envelopes, 
shipping labels and tags before removing or destroying them.

D. Mounting.

CAUTION

The selection of the mounting location for the device, its controls and the routing of the wiring is to 

be accomplished under the direction of the facilities and the safety engineer.

The speaker is intended to be mounted on any relatively flat and rigid surface. Hardware for 
mounting the speaker to the surface is left up to the installer.

Mounting to wall, ceiling, or to electrical boxes is accomplished without the need of adding a 

steel฀plate฀to฀the฀base.฀Bonding฀straps฀may฀be฀used฀for฀mounting฀to฀beams.฀Mounting฀holes฀in฀

the base should be knocked through as needed.

WARNING

This unit is heavy and should be mounted on a rigid surface capable of supporting  

the weight of the speaker.

E. Electrical Connexions.

WARNING

Do not connect wires when power is applied.

NOTE

Audio wires should be sized properly by your licensed installation electrician for your service  

application.฀This฀cable฀requires฀a฀twisted฀shielded฀pair฀with฀an฀18AWG฀minimum฀and฀should฀

 

produce no more than 15% signal loss over the length of the cable run.

Connect the positive (+) audio line to the red wire and the negative (-) audio line  
to the black wire.

A transformer and power selector switch are installed in the rear housing.

The level of the AM30T may be adjusted by moving the switch setting. Clockwise increases 
the power. Since the same switch and transformer are used for either the 100-volt, 70-volt  
or 25-volt line, the power setting depends upon the amplifier output that is used, 100-volt, 70-
volt or 25-volt.

-2-

Summary of Contents for AM30T













Reviews: