5
WINDOW INSTALLATION/FILLER PANELS
WINDOW INSTALLATON
INSTALLATION
11
10
11
12
13
14
Face of window stop
molding
Side of cabinet
Filler Panel
“X” minus one groove
(3/16”)
Cabinet side seal
Cabinet
Window stop molding
Position 1
Position 2
Position 3
Holes in flange
Upholsterers’ tacks
Hole in slider
Slider
1” long screw
Installing the Window Filler Panels
1.
Measure distance “X” between the face of the window stop
molding and the side of the cabinet (Fig. 9).
Note: Measure both sides of unit separately.
2.
Subtract one groove (3/16”) from “X” measurement to obtain the
required width. Using a sharp knife, score the groove until the
filler panel becomes weak enough to break apart (Fig. 10).
3.
Insert cut edge of the filler panel into the cabinet side seal groove
(position 1). Leave a small space at the bottom of the cabinet side
seal groove (Fig. 11).
Rotate the filler panel backward toward the window frame until
the filler panel clears the window sill. Push the filler panel down
against the window sill (position 2).
Slide the filler panel out from the air conditioner cabinet until the
filler panel flange contacts the window stop molding (position 3)
(Fig. 12).
4.
Attach the filler panel to the face of the window stop molding by
driving upholsterers’ tacks through the holes in the filler panel
flange (Fig. 13).
5.
Pull the sliders out until the sliders contact the face of the window
stop molding (Fig. 14).
6.
Pull bottom window sash down tightly and lock it in place by
installing a 5/8” long screw through the hole in the slider into the
window sash (Fig. 14).
7.
Cut the plastic foam seal to proper length and insert it between
the upper and the lower window sash.
Installing the Chassis into the Cabinet
1.
Slide the chassis into the cabinet.
2
.
Reattach the screws on both sides of the decorative front. Make
sure the power cord aligns with the power cord slot on the
bottom of the decorative front. Make sure the decorative front is
secure before reconnecting the plug and operating the unit.
4.
Cut plastic foam seal to width of window and install between
upper and lower window sash.
5.
Use latex or silicone sealant (not supplied) to fill any minor
openings.
A
A
B
B
C
C
C
C
C
D
D
E
E
F
F
F
G
G
G
G
H
H
I
I
J
J
K
K
L
L
M
N
N
O
O
M
9
