FDI LP3180, User Manual, Page: 16 / 40

FDI
NXP LPC3180 Demo
User’s Manual
FDI
Rev 2 Page 16 9/7/2007
Building Images . Otherwise, the following steps may be used to transfer images to
SDRAM:
The serial connection to the LPC3180 board should be configured according to the steps
outlined in
2.6 Serial Connection .
To properly communicate with the board using J-Link Commander, the J-Link-ARM-KS
JTAG dongle should be connected to J2 on the LPC3180 Board (see Figure 8). J2 is
located between GUI board connectors J12 and J13 on the right-hand side of the
LPC3180 board. For assistance in installing J-Link Commander, please consult section
4.1 .
Figure 8: LPC3180 JTAG Connection
After connecting the LPC3180 Board to the power supply (+5VDC, 2.5A, ), use
the power switch SW1 to apply power on the board. If at any time the board needs to be
reset, push button SW3 may be pressed to reset the LPC3180 without toggling the power
switch.
Images may be downloaded to the LPC3180 Board’s SDRAM by double-clicking on the
“NXP Demo Setup” shortcut file or by entering the following commands manually into
the JLink Commander prompt window:
r
loadbin SIBL_208Mhz.bin, 0
setpc 0
g
h
s
s
s
s
speed 4000
// Switch the Thumb -> ARM
w2 0x0 0xa000