Truck Scanner
5
Before power off, please stop all diagnostic items and return back
to the main interface.
Pull out the diagnostic main test line from the diagnostic interface
of the vehicle. If the device is not equipped with battery, the
device will shut down automatically after disconnecting the main
test line from the diagnostic interface of the vehicle.
Vehicle Diagnostic Preparation
The diagnostic program establishes data connection through the
vehicle electronic control system connected with the equipment,
which can read the vehicle diagnostic information, view the data
flow, and perform action test and other functions. For details of
the functions, please refer to the model which you purchased.
To establish good communication between the diagnostic
program and the vehicle, the following operations need to be
performed:
1)
Turn off the ignition;
2)
Find the diagnostic interface of the vehicle: it is usually
located on the driver side; If the diagnostic interface is not found,
please refer to the vehicle maintenance manual;
3)
Insert one end of the diagnostic main test line into the
device DB-15 connector and tighten the retaining screws. The
other end is connected to the vehicle's diagnostic interface.
Note:
Before the equipment is connected to the vehicle, it is
necessary to judge whether the diagnostic seat of the vehicle is
a standard OBD-II interface or a non-standard OBD-II interface.
The vehicle compatible with OBD-II management system
only needs to use the integrated main test line OBD
connector to connect with the vehicle diagnosis seat and
provide power;
Summary of Contents for F802
Page 13: ...Truck Scanner 13 5 Select J1939 Engine 6 Enter Diagnosis home page...
Page 25: ...Truck Scanner 25...
Page 26: ...Truck Scanner 26...