Fbt VAIE 7M00 Series, Instructions For Use Manual

Page: 86 / 96

38
VAIE 7M00
EN
Label Application See panel Notes
Control input Controlled input contacts
Panel for confi guring the controlled
inputs. To go from one input to
another (from 1 to 7), press
Next
or Prev .
Press Mode to select one of the
following modes:
-
Message input > Edit zone
- Broadcast > Edit zone
Press ‘Edit zone’ to associate a
message with each zone
-
Not active input
- Reset input
Press Control to enable or disable
control over the concerned input.
Press Logic to set the logic
typology attributed to the
concerned input, choosing
between:
-
Positive (active high)
- Negative (active low)
Press Trans to choose the
operating mode:
-
Level : the messages are
activated only for as long as the
input is activated.
-
Transition : activation of the
messages starts with activation of
the input, but can be stopped only
by means of manual resetting or a
reset input.
Press ‘ Escape ’ to exit the screen
page.
Output Relay outputs
Panel for confi guring the outputs.
To go from one output to another
(from 1 to 3), press
Next or Prev .
Activate or de-activate (On/Off ) the
type of event to be associated with
the output in question by pressing
the appropriate buttons.
To leave the screen, press
‘
Escape ’.