VAIE 2000 | Voice Alarm Integrated Systems
System Manual | 2013
UK
0
VAC 2006 • VAR 2006
• dPu amplifiers
IMPoRtaNt NotICE!
all the amplifiers connected to a line must necessarily have progressive addresses, from number 1 onwards (max 16 for each line). to
set the address of each single amplifier, consult the “Settings” section in the instruction booklet of the DPU range (FBt code number
37784).
Supposing you wish to set line
2
for connection to amplifiers of the DPU range: after pressing
LInE 2 > Configure
and selecting
DPU - amplifiers
the
Line 2 configuration
window will open.
In this window it is possible to list the amplifiers (and their models) connected to the lines in question, in addition to indicating whether they are
stand-by amplifiers. The associations between the various different amplifiers and the standby units as selected under the heading “Configuring
the standby amplifiers” (Page 83) are also highlighted. The programme will guide you through the procedure in order to ensure that several rules
are followed:
- The entries are sequential, starting from address 1. If an amplifier half-way down the list is deleted by selecting
model = “none”
as the model,
therefore, all the amplifiers with the next addresses will also be removed.
- One line can manage up to a maximum of two standby units. The first of these is “global”, that is to say it can replace the amplifiers of any other
line of the controller. The second standby unit can be either:
• “global” if there are only two standby units on the lines; or
• “local” if there are additional amplifiers on the line. In this case, the standby unit can only replace amplifiers belonging to the same line as
the unit itself.
The programme carries out cross-checks to ensure that the compilation is correct.
Once you have completed the compilation, press
End
to save the configuration, which will appear associated with line 2 in the main window. As
an alternative, you may press
Cancel
to exit without saving the changes made.
• VAIE 2250 compact system
For line
3
, set a connection to a VAIE 2250 compact system: after pressing
LInE 3 > Configure
and selecting the item
VAIE 2250 - compact
the
Line 3
configuration
window will open.
Once you have set the parameters for all the lines, go on to compile the other
four connections shown in the main window: CTR INPUT, CTR OUTPUT,
EMERGENCY UNITS and BROADCASTING UNITS.
