- 11 -
Arming the System (Cont’d)
WHEN THE SYSTEM IS NOT READY
If the system is not ready to be armed, the READY light will be off and the
display will show which zone or zones are not ready. The following conditions
will be indicated by the zone lights (LED keypad) or described on the display:
Fast Blink ................................. Alarm or tamper condition
Slow Blink/Low Intensity ..... Bypass
Slow Pulse ................................ Trouble, problem with RF receiver, or low
battery
Solid On .................................... Zone faulted
Example: If the READY light is not lit and the Zone 1 light is solid on, an
alarm sensor on Zone 1 is faulted. This might mean that a door is open or
someone is walking in view of a motion sensor. Check all sensors on Zone 1
and resolve the problem. In this example, the display shows the following:
NOT READY
PART 1
and
NOT RDY
ZN 1
FRONT DOOR
When all sensors are restored, the READY light will come on and the zone
light will go out.
Determine which zone or zones are not ready, resolve the problem, and arm
the system normally. If the problem cannot be resolved, you may bypass the
zone that is not ready. Bypassing should only be done if the problem on the
zone cannot be resolved, OR if you intentionally wish to leave the zone
disarmed. For example, you would leave the zone disarmed if you plan to
keep the window open for ventilation. Zones that are bypassed are not
protected when the system is armed. See To Bypass A Zone on the
following page for a description of the procedure.
