FAZUA RIDE 60, Original Instructions Manual

Page: 64 / 96

English | Original instructiOns
64
7 TROUBLESHOOTING
1. If your e-bike or drive system does not function as desired, first check whether
the fault can be rectified using the "Troubleshooting" overview table below.
2. If necessary, contact a FAZUA Certified Partner or visit the FAZUA service plat-
form (https://fazua.com/de/support), if:
• the error is not listed in the overview table,
• the error is listed in the overview table, but it cannot be corrected in the
way described here or you are unsure.
TROUBLESHOOTING" OVERVIEW TABLE
Problem possible Reason / Solution
The engine
feels weaker
than usual.
The drive system is brand new.
→
Wait until the drive system is "run in". The drive system needs
a few miles to develop its full power
It is very hot and the heat management of the battery and/or
drive unit limits the performance.
It is very cold and the battery (=lithium-ion battery) does not
deliver the usual performance.
The upper LED
on the control
element/display
lights up/
flashes red.
There is a connection error between the drive unit and battery.
Dirt on the connectors or jammed cables may be preventing the
connection.
→
Clean the connectors to be able to insert the battery properly.*
The upper LED
on the control
element/display
lights up/
flashes yellow.
There may be a bad connection between the speed sensor and
the bottom bracket.
→
Check that the speed sensor and magnet are correctly located
in their receptacle on the rear wheel. If you cannot find any
faults, contact a FAZUA Certified Partner.
The white LEDs
of the control
element/
display flash.
Software update
→
After a new firmware update, the control element is updated
automatically. In this case, please wait and do not switch off the
control element until the LEDs stop flashing
* This applies only if your e-bike is equipped with a removable battery (See Chapter 23 “Function and model variu-
ants of the battery”).