EN-48
evation |
18.1
Correct position/alignment
For the drive system to function correctly, the speed sensor and the spoke
magnet must be correctly positioned and aligned on the rear wheel.
• The spoke magnet must be positioned on the spoke so that it can
move past the speed sensor freely at the height of the marking.
If the spoke magnet and speed sensor are too close together and
there is a risk of them coming into contact, the two parts could be
damaged and may need to be replaced.
• The distance between the mark on the speed sensor and the spoke
magnet must be in the range between
4
–
15
mm.
If the distance between the speed sensor and spoke magnet
is outside the specified range, or the speed sensor is not
correctly connected, the drive function will work in "Soft
Fault" mode.
More detailed information can be found
→
in chapter
22
.
1
"Status
display" or in chapter
26
.
1
"Status display".
18.2
Correcting incorrect position/alignment
If you notice that the drive system is in "Soft Fault" mode because the
speed sensor and spoke magnet are not correctly aligned, proceed as
follows:
1. Using a screwdriver, carefully loosen the fixing screw on the spoke
magnet.
2. To set the correct distance between the mark on the speed sensor and
the spoke magnet:
• Move the spoke magnet vertically on its spoke (up/down) if neces-
sary.
• Turn the spoke magnet around its own axis if necessary.
FAZUA Benutzerhandbuch_EN.indb 48
FAZUA Benutzerhandbuch_EN.indb 48
26-Feb-20 12:47:14
26-Feb-20 12:47:14
- 58 -
