Fayat Dynapac Redline DRF25-70C, Instruction Manual

Page: 231 / 361

E 10 31
Mounting the big ski bracket on the crossbeam
A
The entire big ski construction is mounted laterally on the crossbeams. To do so, the
two crossbeam brackets must first be mounted. The crossbeam bracket design dif-
fers slightly depending on the paver finisher which is used.
During assembly, it is possible either to bolt the brackets directly at the existing
bores (A) or to secure them to the crossbeam using clamping plates (B).
A
The front bracket is mounted directly behind the traction point; the rear bracket is
mounted at approximately the height of the auger.
- Mount both holders (1) to the crossbeam with corresponding bolts (2).
- or
- Place both clamping plates (3) over the crossbeam at the corresponding point and
mount with bolts (4) and sleeves (5).
A
For different crossbeam thicknesses, use the mounting's corresponding bores.
- The mounting tube is aligned via the two bolts (2).
A
Align the bracket vertically.
1
B
2
A
3
5
2
4