Manual No. SCAZ043075 1.7.01
32
E&OE
M25H Road Sweeper
Operating Instructions
Driving modes
Normal drive mode
Before driving, the following conditions must be observed:
All sweeping equipment must be raised and retracted. Wander hose in the storage position.
The sweep mode switch must be off.
The vehicle must be stationary, handbrake on, yellow drive control lever at neutral
w
and engine off.
1. Turn the ignition key and start the engine. See page 21.
2. Select forward
q
or reverse
e
using the yellow drive control lever, direction symbol will illuminate on the
instrument panel.
3. Release the handbrake. Press accelerator to move vehicle in selected direction.
Sweep mode
Before selecting sweep mode, the following conditions must be observed:
The engine must be running.
The sweep mode switch must be off.
The vehicle must be stationary, handbrake on, yellow drive control lever at neutral and engine off.
1. Turn on the warning beacons . See page 21.
2. Switch on sweep mode . Sweep mode illuminates on instrument panel (engine RPM increases to default).
If engine RPM remains at idle (950 RPM) the engine increase switch
can be used to adjust the RPM, 1250 RPM is considered the most efficient setting
for normal sweeping, however it may be necessary to increase RPM in certain circumstances, i.e. full load, uphill.
Although 1250 RPM is considered best for normal sweeping, engine RPM may be reduced when sweeping light or sparsely distributed materials.
Experience will enable the operator to judge the best RPM for the sweeping conditions.
3. Switch on the suction fan .
4. Select the desired sweeping equipment. See page 28.
5. Switch on the dust suppression water if required, it is advisable to use dust suppression water if the areas to be swept are in a dry condition.
6. Place the multi function leaver in the on position. See page 29.
7. Select forward on the yellow control lever. Release the handbrake. Slowly depress accelerator to move the vehicle.
Cruise control
- With vehicle at the desired speed, select cruise control . Can be overridden by the accelerator pedal, and is cancelled by using the foot
brake or by pressing the switch. Only works in sweep mode.
1
2
3
Summary of Contents for SCARAB M25H
