Operation
BOMAG
26
BT 60/4 BT 65/4
4.6
Changing the tamper foot
plate
Fig. 26
●
After changing the tamper foot plate (Fig. 26)
tighten the 4 fastening screws with a tightening
torque of 60 to 70 Nm (44 to 52 ft.lbs).
i
Note
When changing the tamper foot to a different width
use only genuine BOMAG parts.
After changing the tamper foot check the engine
speed, adjust it if necessary.
4.7
Loading and transport
!
Danger
Danger of accident!
Always shut the engine down to transport the
tamper to lay it on its side.
Make sure that persons are not endangered by
the machine tipping or sliding off.
Lash the machine down, so that it is secured
against rolling, sliding and turning over.
For lifting the machine attach the lifting gear
only to the cross strut on the engine protection
bow.
The machine should not swing about too much
when being lifted.
Do not stand under suspended loads.
Use only safe lifting gear of sufficient load
bearing capacity
Fig. 27
●
Always shut the engine down for transport.
●
Transport the tamper only lying down (Fig. 27)
on the castors.
Go to
Discount-Equipment.com
to
order your parts
