Favells Solgrill 2, User Manual, Page: 16 / 17

15
Burner will not light using
ignitor Electrical issues:
1. Electrode cracked or broken;”
sparks at crack.”
2. Electrode tip not in proper
position
3. Wire and/or electrode covered
with cooking residue.
4. Wires are loose or disconnected
5. Wires are shorting (sparking)
between ignitor and electrode.
6. push button sticks at botto
between ignitor and electrode
1. Replace electrode.
2. Tip of electrode should be pointing toward port hole
in burner. The distance should be 1/8” to 3/16”. Adjust
if necessary.
3. Clean wire and or electrode with rubbing alcohol and
clean swab.
4. Reconnect wires or replace electrode/wire assembly.
5.Replace ignitor wire
6.Replace ignitor
7. Inspect wire insulation and proper connection.
Replace wires if insulation is broken.
Burner will not mach light See ”gas issues;” on previous page
2. Improper method of
match-­‐lighting
1. See “match-­‐lighting” section of use and care.
Sudden drop in gas flow or
low flame 1. Grease buildup.
2. Excessive fat in meat.
3. Excessive cooking temperature 1. Clean burners and inside of grill/ firebox
2. Trim fat from meat before grilling.
Flames blow out High or gusting winds. Low on LP
gas.
Excess flow valve tripped. Turn front of grill to face wind or increase flame height.
Refill LP tank.
Refer to “sudden drop in gas flow” above.
Persistent grease fire Grease trapped by food buildup
around burner system. Turn knobs to OFF. Turn gas off at LP tank. Leave lid in
position and let fire burn out. After grill cools, remove
and clean all parts
Flashback…
(fire in burner tube(s) Burner and burner tubes are
blocked Turn knobs to OFF. clean burner and/or burner tubes.
See burner cleaning section of use and care manual
Flare-­‐up 1. Grease buildup.
2. Excessive fat in meat.
3. Excessive cooking temperature 1. Clean burners and inside of grill/ firebox
2. Trim fat from meat before grilling.
3. Adjust (lower) temperature
Unable to fill LP tank Some dealers have older fill nozzles
with worn threads. Turn worn nozzles don’t have enough “bite” to engage
the valve. Try a second LP dealer.
One burner does not light
from other burner Grease buildup or food particles in
end of carryover tube Clean carry-­‐over tube with wire brush
If your problem is not resolved from the information above, please call the Gas grill helpline.
a)
Turn the burner on for 15 to 20 minutes. Grease drippings will be burned off from your grill as well as
your lava rock. Ensure appliance is cold before continuing.
b)
Grids should be cleaned periodically by soaking and washing in soapy water.
c)
The interior surfaces of the grill housing cover should also be washed with hot, soapy water. Use a wire
brush, steel wool or a scouring pad to remove stubborn spots.
d)
Periodically check the burner to see that it is free from insects and spiders which may clog the gas
system, deflecting gas flow. Ensure to clean venturi pipes on burner very carefully, make sure that there
are no obstructions. We recommend that you use a pipe cleaner to clean the venturi pipe area.
e)
Any modifications of this appliance may be dangerous and are not permitted.
13. Gas grill Safety Hints