10
6. Preparation
You will need LPG gas bottle and proper regulators under the gas pressure to operate this gas grill. The
regulators should be comply with EN12864 with current version and national regulation.
See point 9 for farther instructions.
Energy saving tips:
a)
Reduce the opening time of the lid.
b)
Turn the grill off as soon as cooking is completed.
c)
Preheat the gas grill for 10 to 15 minutes only.
(Except for the first use)
d)
Do not preheat longer then recommended.
e)
Do not use a higher setting than required.
Connect the hose and regulator to the gas container at the left side of the gas grill.
Keeping in mind that the gas container must be kept away from heat and in a safe position.
The hose dimension is 8mm-‐10mm diameter.
7. Installation
After purchasing your gas bottle you will then be ready to set it up with your gas grill.
a)
When changing the gas bottle which shall be carried out away from any source of ignition.
Position
the gas bottle can both underneath or at the side of your gas grill, keeping in mind that the bottle must
be kept away from heat and in a safe position.
b)
When ready to use your gas grill insert the regulator into the gas bottle valve and tighten firmly.
The
Length of hose recommended which shall not exceed 1.5m.
Warning:
Before attempting to light your gas grill you must refer to your lighting instructions and
warning / safety points.
Check the hose before each use, searching for cracking, cuts or any abrasions. If the hose is found to be
faulty in any way do not attempt to use your gas grill.
When changing your gas bottle ensures that there are no sources of ignition close by i.e. fires, cigarettes,
naked flames etc. Make sure that the appliance is switched off.
Ensure that the hose is not subjected to twisting
which will affect the gas flow when using your gas grill.
Also the hose must not have undue tension and must not touch any part of the gas grill which may be hot.
Please choose flexible hose whose heatproof higher than 80
Flexible tube should be changed every 2 years;
It’s necessary to change the flexible tube when the
national conditions require it.
How to change your cylinder
These cylinders take a regulator which incorporates a switch for the on/off control of the gas supply. No
spanner is required.
How to connect a gas bottle
a)
Turn the orange cap so that the arrow is pointing to the gap in the shroud.
b)
Remove the orange safety cap by pulling the lanyard out, then out. Do not use tools. Leave the cap
hanging.
c)
Check that the black sealing washer is fitted inside the cylinder valve. Place the regulator down over the
valve with switch.
d)
Turn the switch clockwise on gas bottle-‐then turn on the gas grill as instructed.
Summary of Contents for Solgrill 2
