23
LEVELLING
The appliance is provided with adjustable small feet
placed in the back and front corners od the base.
By adjusting the small feet (see diagram) it is
possible to change the height of the appliance so as to
ensure a better levelling with other surfaces and a
uniform distribution of the liquids contained in pans
or pots.
Electrical connections
Any electrical work required to install this
cooker should be carried out by a qualified
electrician or competent person, in
accordance with the current regulations.
THIS COOKER MUST BE
EARTHED.
The manufacturer declines any liability
should these safety measures not be
observed.
This hob is designed to be connected to a
230 V 50Hz AC electrical supply.
Before switching on, make sure the electricity supply
voltage is the same as that indicated on the hob rating
plate. The rating plate is located on the oven frame.
The cooker is supplied without supply cord. A
flexible supply cord must be fitted, in accordance
with the specification given in the relevant tables.
NOTE:
The earth wire should be about 2 cm. longer
than the live and neutral wires.
The cooker should be connected to a double pole
switch with a minimum gap of 3 mm. between the
switch contacts and of a type suitable for the required
load in compliance with the current electric
regulations.
The switch must not break the yellow and green earth
cable at any point.
Ensure that the cooker supply cord does
not come into contact with surfaces with
temperatures higher than 50 deg. C.
Supply Cable Specifications
and Wiring Diagram
230V 3~
1 2 3 4 5
L1 L2 L3 PE
230V 1~
1 2 3 4 5
L1 N PE
400V 2N~
1 2 3 4 5
L1 L2 N PE
400V 3N~
1 2 3 4 5
L1 L2 L3 N PE
Section
of cable
(min.)
4 x 1.5 mm
2
Section
of cable
(min.)
3 x 2.5 mm
2
Section
of cable
(min.)
4 x 2.5 mm
2
Section
of cable
(min.)
5 x 1.5 mm
2
Suitable supply cable types are listed below.
- H07 RN-F
- H05 RN-F
- H05 RR-F
- H05 VV-F
