2
www.fastTT.bike
FastTT PDA Adapter Kit Installation Guide
Congratulations on purchasing your FastTT PDA Adapter Kit to fit
your Profile Design Aeria Evo base bar!
The following instructions will guide you through the installation process.
There is one left side and one right side adapter stack in each pack. Each adapter stack includes
the following components:
FITTING THE ADAPTER
The supplied M6 bolts are inserted into the base bar from below. If you are
using the 10mm spacer supplied with the kit, then the 40mm bolts are used.
If you are NOT using the spacer then the 30mm bolts are used.
NOTE: Using the incorrect length bolts will prevent the adjustable angled
riser from tightening up correctly and may cause slippage.
Insert the nuts into the riser block and attach the base bar bolts through the
base bar. The nuts will sit snugly in the riser block when tightening and don’t
require a wrench to hold them in place. Tighten the base bar bolts to 6Nm.