Fastrax IV, Instruction Manual, Page: 35 / 92

29
Follow steps below to program the Pattern:
1. Press MENU to display the main menu on the monitor. Scroll to Pattern and push the
Joystick to the right to enter the pattern menu. Or just press the PTRN key on the
keyboard.
2. To edit the pattern title, follow the procedure of the auto scan above to edit titles.
3. Select the desired pattern to be programmed by pushing the Joystick up or down. If the
“Sec” is not 000, a pattern has already been recorded. Patterns can be overwritten.
4. Select the desired pattern (Set) then twist the Joystick.
5. Display the “set pattern”.
6. Press and hold down the CTRL key while controlling the camera direction and zoom
with the Joystick. The dome will be automatically recorded until you release the CTRL
key. Or press IRIS Open then the “CTRL” displays. Move the position and the zoom
position. Press IRIS Close then the “CTRL” disappears.
7. Select Save and Exit and push the Joystick to the right. Press ESC to exit the program
without saving.
Note : Press the HOME key at any programmed position to delete the pattern.
Note : If total recording time reaches 500 seconds, it will automatically stop for a
moment.
3.9 Alarm