17
---
: blank position
SCAN TYPE
: NORMAL/ VECTOR
DWELL
: 03-99 Sec
003
: Preset (1~240)
A08
: Auto Scan (1~8,10~17)
P01
: Pattern (1~8)
T02
: Tour (1~8)
Follow the steps below to program the Tours:
1. Press
MENU
to display the main menu on the monitor. Scroll to Tour and push the
Joystick
to the right to enter the Tour menu. Or just press the
TOUR
key on the
keyboard.
2.
Select the‖ NUMBER‖ and set the desired number by pushing the
Joystick
left or right.
3. Choose a blank position to be programmed by pushing the
Joystick
up, down, right,
or left.
4. To add a stored preset, twist the
Joystick
then the stored preset number displays.
5. To place functions other than preset, press
TOUR
,
PTRN
, or
SCAN
for Tour, Pattern
or Auto Scan respectively.
6. You can also overwrite the programmed number and to remove a stored number from
the Tour, press the
HOME
key on the stored number, a blank position mark (---) will be
displayed.
7. Repeat Step 2 through 5 for each desired position. Each title will be displayed on top
of the line.
8. To edit the title, follow the procedure of the auto scan above to edit titles
9. Select Save and Exit and push the
Joystick
to the right. Press
ESC
to exit the program
without saving.
You can expand the Tour sequence by calling other programmed tours.
NOTE: The speed applies in the vector mode only.
NOTE: In the Tour mode, in conjunction with preset and Auto Scan, you can make the camera
travel from a preset position to another preset position at a specific speed.
TOUR SETUP
NUMBER : 01
TITLE : T01
SCAN TYPE : NORMAL
SPEED : 5 STEP
DWELL : -- SEC
003 A08 --- --- --- --- ---
--- --- --- --- --- --- ---
--- --- P01 --- --- --- ---
--- T02 --- --- --- --- ---
--- --- --- --- --- --- ---
--- --- --- --- --- --- ---
SAVE AND EXIT(ESC TO CANCEL)