C d 39
Helvetica Condensed
Helvetica
Chapter 6— Using Test and Service Mode
EasyCoder 4420 and 4440 Bar Code Label Printer User’s Manual
71
Using Forms Adjust
If the label prints too close to one edge, you can reposition it by using the
X forms adjust and Y forms adjust features. The X forms adjust controls
the position of the printing area along the length of the label. The Y forms
adjust controls the position of the printing area along the width of the
label.
The following illustration shows the default X and Y origins.
*FORMAT*
*FORMAT*
44XXU065.eps
➤
➤
-X
Y
➤
+X
+Y
➤
Direction of media from printer
Origin (Ø,Ø)
Leading
edge
Default X and Y origins:
This illustration shows the default X and Y origins. You can
control the default X origin (top of form) with PrintSet or with the Test and Service DIP
switches. You can control the default Y origin with the DIP switches only.
Note:
An image printed on direct thermal media may have an X origin
position, which is slightly different than the same image printed on
thermal transfer media. Always use X forms adjust and Y forms adjust with
the same media type that you plan to use for printing labels.
The default X origin is 0.10 inch (20 dot increments) from the leading
edge of the label. You can move the X origin forward or backward 30
increments, where each increment is 5 mil.
The default Y origin is 0.00 inch from the edge of the label. You can move
the Y origin down 30 increments, where each increment is 5 mil.